74 Search Results

Asphaltene precipitation/deposition adversely affects various oil and gas processes, such as oil recovery, transportation, and petroleum processing. The resulting increase in viscosity of crude oil decreases distillate yields creating unstable phase separation. Deep eutectic solvents (DESs) have recently gained interest as inhibitors of asphaltene aggregation. The goal of the present study is to derive the mechanism of inhibition of petroleum asphaltene aggregation by a novel screening of DESs. An archipelago-based chemical structure of asphaltene was adopted for performing quantum chemical calculations. The structure was used in the conductor-like screening model for real solvents (COSMO-RS) model to screen potential DESs formore » asphaltene precipitation. It was found that DESs containing thymol were the most promising of the 153 DES combinations screened. The COSMO-RS predictions were validated experimentally using solubility data of asphaltene in DESs. Among the studied DESs, thymol-diphenyl ether provided the highest solubility for asphaltene, which was further validated using the experimental and the COSMO-RS predicted data. In addition, to characterize the structural interactions between asphaltene and DESs, Fourier transform infrared (FTIR) spectroscopy and nuclear magnetic resonance (NMR) measurements were performed. It was found that strong interaction between asphaltene and the DESs is responsible for the higher asphaltene dispersion. Finally, the present approach opens pathways to rationally design and understand the impact of structural variation of DESs based on their interactions with asphaltene.« less

Abstract Developing atomically synergistic bifunctional catalysts relies on the creation of colocalized active atoms to facilitate distinct elementary steps in catalytic cycles. Herein, we show that the atomically-synergistic binuclear-site catalyst (ABC) consisting of $$$${{{{{\rm{Zn}}}}}}^{\delta+}$$$$ ${\mathrm{Zn}}^{\delta +}$ -O-Cr ⁶⁺ on zeolite SSZ-13 displays unique catalytic properties for iso-stoichiometric co-conversion of ethane and CO ₂ . Ethylene selectivity and utilization of converted CO ₂ can reach 100 % and 99.0% under 500  °C at ethane conversion of 9.6%, respectively. In-situ/ex-situ spectroscopic studies and DFT calculations reveal atomic synergies between acidic Zn and redoxmore » Cr sites. $$$${{{{{\rm{Zn}}}}}}^{\delta+}$$$$ ${\mathrm{Zn}}^{\delta +}$ ( $$$$0 \, < \, \delta \, < \, 2$$$$ $0<\delta <2$ ) sites facilitate β-C-H bond cleavage in ethane and the formation of Zn-H ^{δ -} hydride, thereby the enhanced basicity promotes CO ₂ adsorption/activation and prevents ethane C-C bond scission. The redox Cr site accelerates CO ₂ dissociation by replenishing lattice oxygen and facilitates H ₂ O formation/desorption. This study presents the advantages of the ABC concept, paving the way for the rational design of novel advanced catalysts.« less

Most ultrasound-based processes root in empirical approaches. Because nearly all advances have been conducted in aqueous systems, there exists a paucity of information on sonoprocessing in other solvents, particularly ionic liquids (ILs). In this work, we modelled an ultrasonic horn-type sonoreactor and investigated the effects of ultrasound power, sonotrode immersion depth, and solvent’s thermodynamic properties on acoustic cavitation in nine imidazolium-based and three pyrrolidinium-based ILs. The model accounts for bubbles, acoustic impedance mismatch at interfaces, and treats the ILs as incompressible, Newtonian, and saturated with argon. Following a statistical analysis of the simulation results, we determined that viscosity and ultrasoundmore » input power are the most significant variables affecting the intensity of the acoustic pressure field (P), the volume of cavitation zones (V), and the magnitude of the maximum acoustic streaming surface velocity (u). V and u increase with the increase of ultrasound input power and the decrease in viscosity, whereas the magnitude of negative P decreases as ultrasound power and viscosity increase. Probe immersion depth positively correlates with V, but its impact on P and u is insignificant. 1-alkyl-3-methylimidazolium-based ILs yielded the largest V and the fastest acoustic jets – 0.77cm³ and 24.4ms^-1 for 1-ethyl-3-methylimidazolium chloride at 60W. 1-methyl-3-(3-sulfopropyl)-imidazolium-based ILs generated the smallest V and lowest u – 0.17cm³ and 1.7ms^-1 for 1-methyl-3-(3-sulfopropyl)-imidazolium p-toluene sulfonate at 20W. Sonochemiluminescence experiments validated the model.« less

Derived from renewable feedstocks, such as biomass, polylactic acid (PLA) is considered a more environmentally friendly plastic than conventional petroleum-based polyethylene terephthalate (PET). However, PLA must still be recycled, and its growing popularity and mixture with PET plastics at the disposal stage poses a cross-contamination threat in existing recycling facilities and results in low-value and low-quality recycled products. Hybrid upcycling has been proposed as a promising sustainable solution for mixed plastic waste, but its techno-economic and life cycle environmental performance remain understudied. We propose a hybrid upcycling approach using a biocompatible ionic liquid (IL) to first chemically depolymerize plastics andmore » then convert the depolymerized stream via biological upgrading with no extra separation. Here we show that over 95% of mixed PET/PLA was depolymerized into the respective monomers, which then served as the sole carbon source for the growth of Pseudomonas putida, enabling the conversion of the depolymerized plastics into biodegradable polyhydroxyalkanoates (PHAs). In comparison to conventional commercial PHAs, the estimated optimal production cost and carbon footprint are reduced by 62% and 29%, respectively.« less

This article outlines the technical and economic potentials of lignin in unlocking sustainable biorefineries. The benefits of using this highly functionalized biopolymer for the growth of sustainable economy have been highlighted. But practically, the possibility of commercially substituting petroleum oil with lignin is still not very high as the estimated biofuel production cost is 2–3 times higher than the former one. However, with the advancement in technology and more efficient measures by biorefineries such as storing and processing the biomass near the field so as to reduce the transportation cost, it is possible to gain higher profits. Companies like Domtar,more » Stora Enso, Borregaard’s LignoTech, VITO, and Chemelot InSciTe have been promoting commercial value of lignin. The growth of lignin market after the start-up production at various sites has been discussed in this review. Combining the complete “start-to-finish” analysis with economic evaluation gives a pragmatic overview of the possibilities whether lignin will join petroleum oil as an efficient and cost-effective renewable source.« less

A systematic summary on the current state-of-art of the formation, identification, and further valorization of oligomeric products during various lignin depolymerization processes.

Ionic liquids (ILs) have unique solvent properties and have thus garnered significant interest. However, exhaustive experimental determination of the physicochemical properties of ILs is unrealistic due to the large structural diversity of anions and cations, their high cost, the requirements of elevated temperature and pressure, and the time required. To circumvent these experimental costs, computational approaches to accurately calculate these properties have emerged. Here in the present study, we present a demonstration of two machine learning (ML) models for the prediction of two critical IL physical properties, the surface tension and the speed of sound, across a wide range ofmore » temperatures and pressures. The models make use of molecular descriptors derived from the COSMO-RS, a quantum chemical-based model. The ML models show excellent agreement with experimental observations, with an R2 value of 0.96–0.99 and RMSE of 1.71 mN/m and 16.12 m/s for the surface tension and speed of sound, respectively. This work paves the way for the development of COSMO-RS-informed ML models for the prediction of IL properties which can help to further optimize and accelerate technology development for ILs.« less

Abstract Lignocellulose forms plant cell walls, and its three constituent polymers, cellulose, hemicellulose and lignin, represent the largest renewable organic carbon pool in the terrestrial biosphere. Insights into biological lignocellulose deconstruction inform understandings of global carbon sequestration dynamics and provide inspiration for biotechnologies seeking to address the current climate crisis by producing renewable chemicals from plant biomass. Organisms in diverse environments disassemble lignocellulose, and carbohydrate degradation processes are well defined, but biological lignin deconstruction is described only in aerobic systems. It is currently unclear whether anaerobic lignin deconstruction is impossible because of biochemical constraints or, alternatively, has not yet beenmore » measured. We applied whole cell-wall nuclear magnetic resonance, gel-permeation chromatography and transcriptome sequencing to interrogate the apparent paradox that anaerobic fungi (Neocallimastigomycetes), well-documented lignocellulose degradation specialists, are unable to modify lignin. We find that Neocallimastigomycetes anaerobically break chemical bonds in grass and hardwood lignins, and we further associate upregulated gene products with the observed lignocellulose deconstruction. These findings alter perceptions of lignin deconstruction by anaerobes and provide opportunities to advance decarbonization biotechnologies that depend on depolymerizing lignocellulose.« less

Growing interest in sustainable sources of chemicals and energy from renewable and reliable sources has stimulated the design and synthesis of renewable Schiff-base (iminium) ionic liquids (ILs) to replace fossil-derived ILs. In this study, we report on the synthesis of three unique iminium-acetate ILs from lignin-derived aldehyde for a sustainable “future” lignocellulosic biorefinery. The synthesized ILs contained only imines or imines along with amines in their structure; the ILs with only imines group exhibited better pretreatment efficacy, achieving >89% sugar release. Various analytical and computational tools were employed to understand the pretreatment efficacy of these ILs. This is the firstmore » study to demonstrate the ease of synthesis of these renewable ILs, and therefore, opens the door for a new class of “Schiff-base ILs” for further investigation that could also be designed to be task specific.« less